Hioki 3196 - Battery Pack Charging

1
2
3
4
5
6
7
8
9
10
11
Maintenance and Service
9.3 Battery Pack Charging
139
When first purchased, the 9459 BATTERY PACK may not be fully
charged due to self-discharge. Before using the pack the first time,
be sure to charge it completely.
When completely charged, recorded data is backed up for about
30 minutes when the instrument is turned off.
When using the 9459 BATTERY PACK without the 9458 AC
ADAPTER, when the battery charge is depleted, the low-battery
symbol ( ) appears.
When this mark appears, connect the 9458 AC ADAPTER to
recharge the 9459 BATTERY PACK.
9.3 Battery Pack Charging
1. Connect the 9458 AC ADAPTER.
2. Turn the POWER switch On.
The POWER LED should light green
to indicate charging.
(Battery indicator lights red)
Charging should finish within about
two hours.
When the battery indicator turns
white, charging is finished.
(
)
3. When charging is finished,
start measuring or turn the
Power switch Off.
Power On
9458 AC ADAPTER
1
2
Charging the Battery Pack
Charging is disabled when the Power switch is Off.
Verify that the battery is properly charged before using it.
If the battery is properly charged, the indicator appears when
the AC Adapter is unplugged.
• This instrument is designed to charge the 9459 BATTERY
PACK during normal operation.When the 9458 AC ADAPTER
is used, the charging indicator is displayed while measuring,
but measurements are not affected.