9.4 Battery Pack Replacement and Disposal
140
Quick Start Manual
Å@
9.4 Battery Pack Replacement and Disposal
• To avoid electric shock, turn off the power switch and dis-
connect the voltage cords, clamp-on sensors and power
cord before replacing the battery pack.
• To avoid the possibility of explosion, do not short circuit,
disassemble or incinerate the battery pack. Handle and dis-
pose of batteries in accordance with local regulations.
• The battery pack can be expected to be recharged about 500
times, or for about one year before replacement.
Replace the pack only with the HIOKI Model 9459 BATTERY
PACK.
• The battery pack is subject to self-discharge. Be sure to charge
the battery before initial use. If the battery capacity remains
very low after correct recharging, the useful battery life is at an
end.
1. Turn the instrument over, remove
the screw affixing the battery
compartment cover, and remove
the cover.
2. Remove the battery pack and
disconnect the plug from the
connector.
(This is easy to do when the
instrument is upside down.)
3. Connect the plug from the new
battery pack, and insert it and its
wiring.
4. Replace the battery compart-
ment cover, and its screw.
Avoid pinching the battery pack
wires.
Required tools: Phillips screwdriver
Replacing the battery pack
To Next Page
Loading...
