Hioki 3196 - 4 Connecting to Lines to be Measured; Connection Procedure

1
2
3
4
5
6
7
8
9
10
11
Connecting to Lines to be Measured
4.1 Connection Procedure
45
Please read the Usage Notes (page 7) before making
connections.
Connecting to Lines to be
Measured 4
4.1 Connection Procedure
Verify that the voltage cord or clamp-on
sensor is properly connected to the input
terminals.
2
Turn on ( | ) the 3196.
1
5
Verify the currently selected connection
states
(the voltage, power and active power selections
for each channel).
6
Check the connection states and set the
appropriate ranges
(check the voltage and current amplitude and
phase on the vector display).
❖Connecting the Voltage
Cords(page 33)
❖Using a Clamp-On Sensor
(Option)(page 37)
❖Turning the Power On/Off
(page 42)
❖ (page 51)
❖ (page 51)
Connect the voltage cords and clamp-on
sensor to the lines to be measured in
accordance with the displayed connec-
tion diagram.
❖ (page 46)
❖ (page 51)
OK
NG
Go to 4
Measurement
❖ Measurement Method(page 57)
VECTOR
3
Set up the connection (wiring) configu-
ration, nominal voltage and frequency.
WIRING
❖ Quick Reference(page 51)
❖ Peripheral Devices(page 109)
❖ Data Recording, Saving,
Loading and Deleting(page 53)
MEASURE
Setting
Details
4
7
Set up for recording or events as
needed.