1
2
3
4
5
6
7
8
9
11
IDX
Appendix
143
Troubleshooting
Appendix
Setting problems
Changing settings
while [RECORDING] or
[ANALYZING] is dis-
played?
In either case, data stored in internal memory is
erased.
Measurement problems
The Start key does not
start recording during
[ANALYZING] opera-
tion!
CAUTION!
Pressing erases all data stored in
internal memory.
The measurement
period is unknown.
Refer to the recording time table for time series graphs.
❖ (page 135)
To measure over a long
period
Install a Flash ATA Card.
If a 128-MB card is installed: the recording period is
about 10 times that listed.
(However, the maximum recording period in all cases is
limited to 31 days.)
The Real-Time View is
not available on the
VIEW screen
The previous event selection is being retained.
Press once to revert to the EVENT screen, then
return to the VIEW screen.
[SETTING]
uring [RECORDING]
peration:
During
operation:
[SETTING]
Return to the setting
mode from analysis
[RECORDING]
Start recording