Hioki BT3562-01 - Page 119

8.5 Message List
115
8
Chapter 8 RS-232C/GP-IB Interfaces
:SYSTem:CALibration:AUTO?
ON/ OFF Queries the automatic self-calibration
setting
138
Trigger Input Measured Value Ouputput
:SYSTem:DATAout
1/ 0/ ON/ OFF Sets measurement value output upon
triggering
138
:SYSTem:DATAout?
ON/ OFF Queries measurement value output
upon triggering
138
Key Beeper
:SYSTem:BEEPer:STATe
1/ 0/ ON/ OFF Sets the key beeper 139
:SYSTem:BEEPer:STATe?
ON/ OFF Queries the key beeper setting 139
Line Frequency
:SYSTem:LFRequency
AUTO/50/ 60 Selects the AC line frequency 139
:SYSTem:LFRequency?
AUTO/50/ 60 Queries the AC line frequency selec-
tion
139
Key-Lock
:SYSTem:KLOCk
1/ 0/ ON/ OFF Sets the key-lock 139
:SYSTem:KLOCk?
ON/ OFF Queries the key-lock setting 139
EXT I/O Output
:SYSTem:ELOCk
1/ 0/ ON/ OFF Sets the external input terminal lock 140
:SYSTem:ELOCk?
ON/ OFF Queries the external input terminal
lock on/off setting
140
Local
:SYSTem:LOCal
Sets local control 140
Saving and Loading Measurement Setting States
:SYSTem:SAVE
<Table No.> Saves the measurement setting state 140
:SYSTem:LOAD
<Table No.> Loads a measurement setting state 140
:SYSTem:BACKup
Backups current measurement con-
figuration
140
Header Present
:SYSTem:HEADer
1/ 0/ ON/ OFF Sets header present 141
:SYSTem:HEADer?
ON/ OFF Queries the header present setting 141
ERR Output
:SYSTem:ERRor
SYNChronous/
ASYNchronous
Sets error output timing 141
:SYSTem:ERRor?
SYNCHRONOUS/
ASYNCHRONOUS
Queries the error output timing setting 141
EOM Output
:SYSTem:EOM:MODE
<HOLD/PULSe> Selects the EOM output mode
142
:SYSTem:EOM:MODE?
(<HOLD/PULSE>) Queries the EOM output mode setting
142
Message ([ ] = optional) Data Contents
( ) = response data
Description Ref
page