121
Outputting and Loading Measurement Conditions (USB Flash Drive)
3
Select whether to output panel data.
Checked Outputs panel data (default
setting).
Notchecked
Does not output panel data.
4
5
Touch
OK to output the selected
measurement conditions to the USB ash
drive.
The output les have the following
extensions:
.SET: Measurement conditions
.ALL: Measurement conditions and panel
data
The output settings are recorded as textual communications commands in a settings le on the
USB ash drive. This le can be sent as a command during initial conguration when writing a
program to a connected instrument.
10
Using a USB Flash Drive
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
Loading...
