Hioki DM7275-01 - Interface Specifications

163
Interface Specications
13.4 InterfaceSpecications
LAN(standard
equipment)
Standard compliance IEEE 802.3
Transmission method 10BASE-T, 100BASE-TX (automatic detection)
Full-duplex transmission
Protocol TCP/IP
Connector RJ-45
Type of information
sent and received
Settings and measurements via communications commands
Settings IP address, subnet mask, default gateway
Communications command port: 1 to 9999
Default settings IP address: 0.0.0.0
Subnet mask: 255.255.255.0
Default gateway: 0.0.0.0 (none)
Communications command port: 23
USB device (standard
equipment)
(Not available when USB
host is selected)
Electrical specications USB 2.0 (full-speed)
Connector Series B receptacle
Class CDC class (USB COM), HID class (USB keyboard mode)
Default setting CDC class (USB COM)
USB host (standard
equipment)
(Not available when USB
device is selected)
Class Mass storage class (FAT16/32 support, no VFAT support)
Capacity limit Up to 128 GB (theoretical value)
Saving of measured
values
• Touching the SAVE key outputs the current measured value
or screen (BMP format).
• All contents of measured value memory can be output to
the USB ash drive from the File Operations screen.
File operations Save settings (with or without panel information), load
settings, delete, change name, display disk information
Settings Output format: TEXT, SCREEN
Default settings Default setting: TEXT
GP-IB(-02model)
Standard compliance IEEE 488.2
Interface actions SH1, AH1, T6, L4, SR1, RL1, PP0, DC1, DT1, C0
Type of information
sent and received
Settings and measurements via communications commands
Settings Device address: 1 to 30
Delimiter: LF, CRLF
Default settings Device address: 1
Delimiter: LF
13
Specications
w ww . . co m
information@itm.com1.800.561.8187