Hioki DM7275-01 - Resetting the Instrument (Reverting the Instrument to Its Factory Settings)

93
Resetting the Instrument (Reverting the Instrument to Its Factory Settings)
7.9 Resetting the Instrument (Reverting the
InstrumenttoItsFactorySettings)
There are two types of reset:
Reset
Initializes the instrument to the factory settings. Panel data and interface
settings will not be initialized.
There are three ways to trigger this reset:
• Selecting the reset command on the SYSTEM screen
• Turning on the instrument while holding down the [AUTO] and [

] keys at
the same time
• Issuing a communications command (
*RST
,
:SYSTem:PRESet
,
:STATus:PRESet
)
Systemreset
Initializes all settings to the factory settings.
There are two ways to trigger this reset:
• Selecting the system reset command on the SYSTEM screen
• Turning on the instrument while holding down the [AUTO], [

], and [

]
keys at the same time
• The clock setting will not be reset.
• For more information about communications commands, see the Communication Command
Instruction Manual on the included application disc.
This section describes how to initiate a reset on the SYSTEM screen.
(Measurement screen) MENU > SYSTEM
1
NORMAL Performs a reset.
SYSTEM Performs a system reset.
2
Touch
OK to perform the reset.
(Example screen: When SYSTEM is
selected)
The Measurement screen will be displayed
once the reset is complete.
7
System Settings
w ww . . co m
information@itm.com1.800.561.8187