Hioki DM7275-01 - Printer Settings

144
Printer Settings
12.1 Printer Settings
1
Turnoffthe9442Printer.
2
Turnonthe9442whileholdingdownthe
[ONLINE] switch and release the switch
once the printer starts printing.
The current settings will be printed. The
following message will be printed after the
settings:
Continue? :Push ‘On-line SW’
Write? :Push ‘Paper feed SW’
3
Press the [ONLINE] switch.
The printer will print the message “
Dip SW-1
”
and enter the software DIP SW1 setting state.
4
Set DIP SW1 switch numbers 1 through
8toonoroffasindicatedinthetable
below.
Example: Press the
[FEED] switch to
set the input method setting to
SERIAL.
The input content will be printed each time
you press the switch so that you can check
the input results after each press. If you
mistakenly enter the wrong setting, go back
and repeat the process from Step 1.
Once you have nished setting switch No. 8,
the following message will be printed again:
Continue? :Push ‘On-line SW’
Write? :Push ‘Paper feed SW’
Set the parameters to the values indicated with check marks.
Switch no. Function
ON
(Press the
[ONLINE] switch.)
OFF
(Press the [FEED] switch.)
1 Input method setting Parallel Serial

2 Print speed Fast

Slow
3 Auto-loading Enable

Disable
4 CR function Carriage return Line feed

5 Setting command Enable

Disable
6
Print density (Set to 100%.)
− OFF

7 ON

−
8 ON

−
w ww . . co m
information@itm.com1.800.561.8187