Hioki DM7275-01 - Page 146

145
Printer Settings
5
Set the DIP SW2 and DIP SW3 switches
as described in the table below (see
Steps3and4).
Once you have nished setting DIP SW3
switch No. 8, the following message will be
printed again:
Continue? :Push ‘On-line SW’
Write? :Push ‘Paper feed SW’
6
Press the [ONLINE] switch or the [FEED]
switch.
This completes the conguration process,
causing the following message to be
printed:
Dip SW setting complete!!
DIP SW2 settings
Set the parameters to the values indicated with check marks.
Switch no. Function
ON
(Press
[ONLINE] switch.)
OFF
(Press [FEED] switch.)
1 Print mode* Normal print (40-row)

Condensed print (80-row)
2
User-dened character
backup
Enable

Disable
3 Character type Normal characters

Special characters
4 Zero character 0

Ø
5 International characters ON

−
6
Print density (Set to 100%.)
ON

−
7 ON

−
8 ON

−
* If you have congured time and date output as described in “9.3 Data Output Settings” (p. 113), set to
condensed print (80-row).
DIP SW3 settings
Set the parameters to the values indicated with check marks.
Switch no. Function
ON
(Press
[ONLINE] switch.)
OFF
(Press [FEED] switch.)
1 No. of data bits 8

7
2 Parity None

Yes
3 Parity setting Odd

Even
4 Control ow HW BUSY XON/XOFF

5
Baud rate
(Set to 9600 bps.)
− OFF

6 ON

−
7 ON

−
8 ON

−
Printing
12
w ww . . co m
information@itm.com1.800.561.8187