Hioki DM7275-01 - Page 2

Measurement process
Measurement process
This section describes voltage measurement as performed in a typical application.
Example use: Measuring a battery’s voltage
Preparations
(1) Position the instrument as desired. (p. 7)
50 mm or more 50 mm or more
150 mm or more
Rear
(2) Perform the pre-measurement inspection. (p. 24)
(3) Connect the power cord. (p. 25)
(4) Connect the measurement cables to the measurement terminals. (p. 26)
(5) Connect the temperature sensor to the TEMP.SENSOR connector.
(When performing temperature measurement or using the temperature compensation) (p. 27)
(6) Congureandconnecttheexternalinterface(asnecessary).
• Using the USB interface (p. 98)
• Using the RS-232C interface (p. 100)
• Using the GP-IB interface (p. 102)
• Using the LAN interface (p. 104)
• Using a USB ash drive (p. 115)
• Using the EXT I/O connector (p. 125)
DM7275A961-00
Power cord To outlet
10
9
8
7
6
5
4
3
2
1
付録
索引
w ww . . co m
information@itm.com1.800.561.8187