Hioki DM7275-01 - Page 58

54
Comparator Measurement (Using a Single Judgment Standard)
Judgment result
Set upper limit and
lower limit values
Statistics display
(p. 84)
The judgment result and statistics sub-
display are shown on the Measurement
screen.
P1,P2 Toggles the statistics display.
CLR Deletes the statistical calculation
results.
Setting the comparator function to ON automatically sets the BIN function to OFF.
Thefollowingjudgmentsmaybeshownwhentheinstrumentisnotabletoperformmeasurement
normally:
Measuredvaluedisplay Judgment
+OvrRng HI (if only a lower limit value was set, IN)
−OvrRng If the absolute value judgment function is disabled: LO (if only an upper
limit value was set, IN)
If the absolute value judgment function is enabled: HI (if only a lower limit
value was set, IN)
NoCntct or −−−−−−− −− (No judgment)
See “3.5 Measurement Error Displays (Displays Other Than Measured Values)” (p. 46)
.
TheSettingsscreencanbedisplayedfromtheMeasurementscreen’ssub-display.
w ww . . co m
information@itm.com1.800.561.8187