Hioki DM7275-01 - Page 67

64
Loading Measurement Conditions (Panel Load Function)
5.2 LoadingMeasurementConditions(PanelLoad
Function)
The panel load function loads panel data that was previously saved in the instrument’s internal
memory.
Panel data can be loaded as follows:
• By means of touch panel operation
• By sending communications commands from an external device
(See the Communication Command Instruction Manual on the included application disk.)
• By sending signals from an external device
See “11 External Control (EXT I/O)” (p. 125), “8 Preparing to Use USB, RS-232C, GP-IB,
and LAN Control” (p. 97)
This section describes how to load panel data using the touch panel.
(Measurement screen) MENU > PANEL
1
Select the panel data to load.
2
3
Touch
OK to replace the current settings
with the settings in the loaded panel data.
w ww . . co m
information@itm.com1.800.561.8187