5.1 Recording Measurement Data
112
• To exit the setup screen, press the
key. No changes will be made to the set-
tings.
• To exit the logging recording mode, press
the key.
When held data is displayed, logging
recording cannot be selected.
Hold down the key for more than one
second to erase the held data and then per-
form the operation below.
Procedure
1. Press the key in standby state.
[MEMO No.] lights up and the available
No. next to the last stored No. blinks.
Exiting Setup Screen or Logging Recording
Mode
Logging recording is not available in the
step voltage test mode (the voltage setting
is STEP) or in the temperature
compensation mode ([
TC
] is on).
Change the voltage setting
3.2.1 Procedure 5. - (page 66)
Exit temperature compensation mode.
4.3.2 "Exiting Temperature Compensation Mode"
(page 96)
To Next Page
Loading...
