Hioki IR3455 - 4 Advanced Measurement; Using Timer; Setting Timer;Conducting Insulation Resistance Measurement

4.1 Using Timer
1
2
3
4
5
6
7
8
9
10
11
付録
索引
85
If the timer is set during insulation resistance measurement,
the measurement automatically ends at the set time.
Selectable time: 30 sec. to 30 min. (When setting over 1
minute, time increments or decrements in minutes.)
4.1.1 Setting Timer/Conducting Insulation
Resistance Measurement
Procedure
1. When the instrument is in a standby
state, press the key.
The time indication will blink.
2. Press the key to set the time.
Advanced
Measurement
4
4.1 Using Timer
What is it used for?
Used to set the instrument to auto-
matically stop at a specified time.