Hioki IR3455 - Checking and Deleting Held Data

3.2 Measuring Insulation Resistance
72
3.2.3 Checking and Deleting Held Data
The following data are held and displayed after insulation
resistance measurement has been completed.
• Insulation resistance (digital value and bar graph)
• Test voltage
• Actual output voltage
• Leakage current
• Elapsed time
•DAR
•PI
Some data may not be displayed. Press the keys shown in
the table below to switch the indication.
To clear the data, press the key for more than one sec-
ond.
Temperature/humidity data will not be cleared.
Checking Held Data
Data indications to be switched Keys used
key
key
Elapsed time  Temperature/humidity
(When the data are held)
key
Insulation
resistance
Leakage
current

 DAR 1 min/ 30 s

PI (10/1 min.)
DAR 1 min/15 s


Test voltage
(setting)
Actual output
voltage

The held data are cleared when power is
turned off. To save the data, use the
memory function.
 See 5 "Recording Measurement Data (Memory
Function)" (page 105).
Deleting Held Data