2.2 Turning Power On and Off
1
2
3
4
5
6
7
8
9
10
11
付録
索引
51
2.2.1 Auto Power Off
• Power is automatically turned off around
10 minutes after the last operation. This
function, however, is not available during
insulation resistance measurement.
•[
APS
] will start blinking around 30 sec-
onds before power is turned off.
• Auto power off is re-enabled upon turning
power on again. ([
APS
] lights up.)
• When the AC adapter is connected to the
instrument, auto power off is disabled.
• When the timer is set or when the instru-
ment is in the step voltage test mode,
auto power off is disabled.
Turn on power while holding down the
key.
Canceling Auto Power Off
To Next Page
Loading...
