3.2 Measuring Insulation Resistance
1
2
3
4
5
6
7
8
9
10
11
付録
索引
71
4. When the voltage falls to about 10 V, the
instrument stops discharging and the
mark and key lamp are turned off.
5. To restart measurement, press the
key to check the set test voltage before
resuming measurement.
• If the key is pressed during
measurement, automatic discharge is
performed before power is turned off.
• If the battery runs low during measure-
ment, the instrument automatically
stops measurement. Automatic dis-
charge is performed and then [LObAt]
appears on the screen.
LastElapsed time of the
Actual output
voltage
(last measurement)
end of measurement measurement value
To Next Page
Loading...
