75
Wireless Communications Function (GENNECT Cross)
• The Z3210 uses wireless technology in the 2.4-G Hz band. If the instrument is close
to a device that uses the same frequency band, such as a wireless networking
device (IEEE 802.11.b/g/n), it may not be possible to establish communications.
• When GENNECT Cross is rst started (i.e., there are no registered devices), it
starts with the connection settings screen.
• On the GENNECT Cross connection settings screen, the connection to the
instrument is automatically registered if the instrument is close (up to eight
instruments).
• Wait 5 to 30 seconds from when the instrument’s power is turned on until the
connection to the instrument is registered. If the instrument is not registered even
after waiting for 1 minute, restart GENNECT Cross and the instrument.
To Next Page
