Hioki IR5050 - Automatic Power Save Function; Recovering from the Automatic Power Save State; Disabling Automatic Power Save Function

73
Automatic Power Save Function
5.2 Automatic Power Save Function
This function can save battery consumption.
The instrument enters the automatic power save state and turns o󰀨 the LCD after
approximately 10 minutes from the last operation or from when the live line warning
display (
) was last lit or blinking.
When the power is turned on, the automatic power save function is enabled
automatically. ([APS] lights up)
[APS] will start blinking around 30 seconds before the instrument enters the
automatic power save state.
Recovering from the automatic power save state
Use the rotary switch to turn the power o󰀨 and on again. The LCD lights up and the
instrument recovers from the automatic power save state.
Disabling automatic power save function
Use the rotary switch to turn o󰀨 the power, and then while holding down the MODE
key, use the rotary switch to turn on the power to cancel the automatic power save
function.
IMPORTANT
The automatic power save function setting is not saved when the power is turned
o󰀨.
HIOKI IR5050A961-00