Hioki RM3544 - 9.4 Auto-Exporting Measured Values (at End

9.4 Auto-Exporting Measured Values (at End of Measurement) (Data Output Function)
134
1
Open the Settings Screen.
2
Open the Communications Interface Settings Screen.
3
Enable or disable auto-exporting (DATA OUT)
4
Select the auto-exporting condition (applied when auto-hold function is set to
ON).
The Settings screen
appears.
Switch the function menu
to P.2/2.
1
2
Move the cursor to the [IF] tab
with the left and right cursor
keys.
1
2
Enable auto-exporting
Disable auto-exporting
(default)
Selection
2
Enable auto-exporting when
auto-hold is set to ON.
Disable auto-exporting even
when auto-hold is set to
ON. (default)
Selection
1