Hioki RM3544 - Holding Measured Values

3.4 Checking Measured Values
41
3
The auto-hold function provides a convenient way to check measured values. Once the
measured value stabilizes, the beeper will sound, and the value will be automatically held.
Canceling auto-hold operation
Hold operation is automatically canceled when the measurement leads are removed from
the measurement target and then brought into contact with the measurement target again.
You can also cancel hold operation by pressing or changing the range and measure-
ment speed. When hold operation is canceled, the HOLD indicator will go out.
Holding Measured Values
1
Open the Settings Screen.
2
Open the Measurement Settings Screen.
3
Enable the auto-hold function.
4
Return to the Measurement screen.
5
While the measured value is being held, the HOLD indicator will light up.
The Settings screen
appears.
Switch the function menu
to P.2/2.
1
2
Move the cursor to the
[MEAS] tab with the left and
right cursor keys.
2
ON
OFF (default)
Selection
1
Return to the
Measurement screen.