Hioki RM3544 - 4.3 Correcting for the Effects of Temperature (Temperature Correction (TC))

4.3 Correcting for the Effects of Temperature (Temperature Correction (TC))
52
Temperature correction converts resistance values to resistance values at standard tem-
perature and displays the result.
For more information about the principle of temperature correction, see "Appendix 4 Tem-
perature Correction (TC) Function" (p. A4).
To perform temperature correction, connect the temperature sensor to the TEMP.SENSOR
jack on the back of the instrument.
See: "2.3 Connecting Z2001 Temperature Sensor (When using the TC)" (p. 27)
4.3 Correcting for the Effects of Temperature
(Temperature Correction (TC))
1
Open the Settings Screen.
2
Open the Measurement Settings Screen.
3
Enable the temperature correction function. (TC)
The Settings screen
appears.
Switch the function menu
to P.2/2.
1
2
Move the cursor to the
[MEAS] tab with the left and
right cursor keys.
2
Enables the TC function
Disables the TC function
(default) (go to step 5)
Selection
1