Hioki RM3544 - Page 75

5.1 Judging Measured Values (Comparator Function)
67
5
• When the auto-hold function is set to ON, the judge delay function is automatically set to
OFF.
• For Non-Free-Run, the judge delay function is automatically set to OFF.
3
Enable the judge delay function.
4
Set the the number of unjudged measurements.
5
Return to the Measurement screen.
Enables the judge delay
function
Disables the judge delay
function (default) (go to
step 5)
Selection
2
1
Move the cursor to the setting you
wish to configure. Make the value
editable with the key.
2
Move the cursor to the digit you
wish to set with the left and right
cursor keys. Change the value
with the up and down cursor keys.
Change
values.
1
Move among
digits.
Setting range: 1 to 100 times (default: 1 times)
3
Accept
( Cancel)
Return to the
Measurement screen.