Hirschmann PAT IFLEX5 - Error Codes E16-E1 C

Service Manual iFLEX5
© Hirschmann Rev. I 0522/17 190154_I.DOC
64
Error Code
Error
Cause
Elimination
E16
Fallen below lower
limit value in
measuring channel
"angle 2"
 Angle potentiometer
defective
 Replace angle sensor
 Electronic component in
the measuring channel
defective.
 Replace sensor unit
E17
Fallen below lower
limit value "length
telescope I (+II)"
 Length potentiometer
defective
 Replace length sensor.
 Electronic component in
the measuring channel
defective
 Replace sensor unit
E18
Front outrigger
overloaded
 Front outrigger
overloaded

E1A
Fallen below lower
limit value in
measuring channel
"slewing angle 1".
 Cable between the
central unit and the
slewing angle sensor
defective or loose. Water
inside the plug of the
angle sensor
 Check cable as well as
plugs, replace, if need be.
 Slewing angle
potentiometer is defective
 Replace slewing angle
sensor
 Electronic component in
the measuring channel
defective
 Replace sensor unit
E1B
Fallen below lower
limit value in
measuring channel
"slewing angle 2"
 refer to E1A
 refer to E1A
E1C
Fallen below lower
limit value in
measuring channel
"luffing jib angle"
 Angle potentiometer
defective
 Replace angle sensor
 Electronic component in
the measuring channel
defective.
 Replace sensor unit