Network Load Control
160
8.2
Multicast Application
UM Basic Configuration L3P
Release
7.1
12/2011
Settings per Port (Table)
“IGMP on”
This table column enables you to enable/disable the IGMP for each
port when the global IGMP Snooping is enabled. Port registration
will not occur if IGMP is disabled.
“IGMP Forward All”
This table column enables you to enable/disable the “Forward All”
IGMP Snooping function when the global IGMP Snooping is
enabled. With the “Forward All” setting, the device sends to this port
all data packets with a Multicast address in the destination address
field.
Note: If a number of routers are connected to a subnetwork, you
must use IGMP version 1 so that all the routers receive all the IGMP
reports.
Note: If you use IGMP version 1 in a subnetwork, then you must also
use IGMP version 1 in the entire network.
“IGMP Automatic Query Port”
This table column shows you which ports the device has learned as
query ports, if “automatic” is selected in “Static Query Port”.
"Static Query Port“
The device sends IGMP Report messages to the ports on which it
receives IGMP requests (disabled=as-delivered state).
This table column also lets you send IGMP Report messages to:
other selected ports (enable) or
connected Hirschmann devices (automatic).
“Learned Query Port”
This table column shows you at which ports the device has received
IGMP queries, if “disable” is selected in “Static Query Port”.
To Next Page
Loading...
Need help?
General
