To Next Page

To Previous Page

Commissioning

qSCALE i2 Cranes (Tool Version 3.0.34) Service Manual / Issue B / 11-2017 / ac.

CAUTION

The crane operator continues to bear ultimate responsibility for safe operation of the crane. The

operator must ensure that he fully understands and follows the displayed notes and instructions

in their entirety.

WARNING

The RCL is not able to provide aid to the crane operator unless it has been properly adjusted

and the correct load capacity chart and the correct operating code have been entered for the

respective rigging configuration. The correctness of the RCL settings must be guaranteed be-

fore beginning crane work in order to avoid damage to property and severe or even fatal injuries

to personnel.

WARNING

This system can be equipped with an external key-operated switch located in the crane opera-

tor's location. This key-operated switch overrides control lever function switch-off by the RCL or

by the hoist limit switch system. This switch may only be used during emergency situations,

and even then, only by authorized personnel. Failure to observe these instructions could result

in damage to property and severe or even fatal injuries to personnel.

WARNING

The RCL cannot perform correctly unless it has been properly adjusted. The prerequisite for this

is making conscientious and correct entries during the set-up procedure in accordance with the

actual configuration of the crane. The correctness of the RCL settings must be ensured before

beginning crane work in order to avoid damage to property and severe or even fatal injuries to

personnel.

NOTE

The calibration menu functions are password protected by an RCL or System password.

Hirschmann qSCALE i2 Service Manual

Other manuals for Hirschmann qSCALE i2