Troubleshooting
© 2016 Hirschmann Automation and Control GmbH · Mobile Machine Control Solutions · www.beldensolutions.com 27/161
qSCALE i2 Cranes (Tool Version 3.0.34) Service Manual / Issue B / 11-2017 / ac.
3.1.3 Error Codes
The qSCALE i2 system uses various error codes to report and log various activity. See the section in
the appendix, Error Code Tables, for a complete list of codes, their cause, and possible solution.
3.1.3.1 Indication of an Event Message
If necessary, a code ‘# ####’ is displayed at the marked location on the display. If several event mes-
sages are simultaneously present, only the most important will be displayed here.
3.1.3.2 Event Classes
The leading digit of an event code indicates the event class.
Depending on the importance of the message they are divided into different classes:
To Next Page
Loading...
Need help?
General