Maintenance and Repair
© 2016 Hirschmann Automation and Control GmbH · Mobile Machine Control Solutions · www.beldensolutions.com 75/161
qSCALE i2 Cranes (Tool Version 3.0.34) Service Manual / Issue B / 11-2017 / ac.
4. The system will now begin the uploading process. The screen will begin to display various
messages as the software loads. This process may take several minutes.
5. Once step 4 has been completed, the console will display the crane model and serial
number and then the home screen. The qSCALE i2 system may now be powered down
(crane ignition key turned to the “OFF” position).
6. The USB flash drive can now safely be removed. Replace the flap.
7. The software has now been uploaded and the system is ready for use.
To Next Page
Loading...
Need help?
General