General Information
1-13
Cleaners, Degreasers
and Solvents
Many chemicals are available to remove
oil, grease and other residue from the
UTV. Before using cleaning solvents,
consider how they will be used and
disposed of, particularly if they are not
water-soluble. Local ordinances may
restrict types of cleaning chemicals.
Refer to Safer in this chapter. Use brake
parts cleaner for brake system
components. Brake parts cleaner leaves
no residue. Electrical contact cleaner is
a powerful solvent used to remove fuel
deposits and varnish from fuel system
components. Use this cleaner carefully,
as it may damage finishes. Most
solvents are designed to be used with a
parts washing cabinet for individual
component cleaning. For safety, use
only nonflammable or high flash point
solvents.
Gasket Sealant
Sealant is used in combination with a
gasket or seal. In other applications,
such as between crankcase halves, only
a sealant is used. Follow the
manufacturer’s recommendation when
using a sealant. Use extreme care when
choosing a different sealant based on its
resistance to heat, various fluids and its
sealing capabilities.
Gasket Remover
Aerosol gaskets remover can help
remove stubborn gasket. This product
can speed up the removal process and
prevent damage to the mating surface
that may be caused by using a scraping
tool. Most of these types of products are
very caustic. Follow the gasket remover
manufacturer’s instructions for use.
Thread locking
Compound
A thread locking compound is a fluid
applied to the threads of fasteners. After
tightening the fastener, the fluid dries
and becomes a solid filler between the
threads. This makes it difficult for the
fastener to work loose from vibration or
heat expansion and contraction. Use
thread locking compound sparingly.
Excess fluid can run into adjoining parts.
Caution
Thread locking compounds are
anaerobic and will stress, crack and
damage most plastics. Use caution
when using these products in areas
where there are plastic components.
Thread locking compounds are available
in a wide range of compounds for
various strengths, temperature and
repair applications. Follow the
manufacturer’s recommendations
regarding compound selection.
Basic Tools
Most of the procedures in this manual
can be carried out with basic hand tools
and test equipment familiar to the home
mechanic. Always use the correct tools
for the job. Keep tools organized and
clean. Store them in a tool chest with
related tools organized together.
Quality tools are essential. The best are
constructed of high-strength alloy steel.
These tools are light, easy to use and
resistant to wear. Their working surface
To Next Page
