Periodic Maintenance
3-8
Place the vehicle on a level surface.
1. Start the engine and let it warm up
for several minutes.
2. Stop the engine and place an oil
pan under the engine.
3. Remove:
• Driver’s seat
• Passenger’s seat
• Console
4. Remove the following parts in this
order.
1. Oil Dipstick (1)
2. Oil Drain Bolt (2)
3. Oil filter cover bolts (4) M6 X
20 and cover (5), sealing O-
ring(6), And oil filter cartridge
(7)
4. Install a new oil filter cartridge
5. Install the oil drain bolt
6. Fill the engine with the proper
amount of engine oil to
between the minimum and
maximum level on the dipstick.
7. Install the dipstick
8. Run the engine to warm it up.
9. Shut off the engine and allow
the engine oil to settle.
10. Recheck the level and adjust
as needed.
Look for any leaks
11. Install the console,
passenger’s seat and driver’s
seat.
To Next Page
Loading...
