Hitachi CP-EX3051WN - Connection to the Network

12
2. Connection to the network
2. Connection to the network
The connection method of wireless /AN and wired /AN is as follows.
Wireless /AN US%-W/-5*)
Item Description
Standard IEEE802.11a/b/g/n/ac
Channel
*1
2.4 *H] : 1a11ch
5 *H] :
36/40/44/48ch W52)
149/153/157/161/165ch W58)
Encryption
*2
WPA2-PSKAES/TKIP), WPA-PSKAES/TKIP),
WEP64/128bit)
%andwidth 2.4 *H] : 20/40MH]
5 *H] :
20/40/80MH]
*1: AYailable channels may Yary according to area.
*2: WEP is only for INFRASTRUCTURE mode.
Wired /AN
Item Description
Standard 100%ASE-T; / 10%ASE-T
Port RJ-45
 The network function is not aYailable when STAND%Y MODE is set
to
NETWORKWO/) or SA9IN* and the projector is in standby mode. Connect
the projector to the network after setting STAND%Y MODE to NORMA/.

SETUP menu in the Operating *uide)
 Depending on the type of wireless network deYice and computer you are
using, the projector may not be able to communicate properly with your
computer, eYen if the computer is eTuipped with a built-in wireless /AN
function. To eliminate communication problems, use a Wi-Fi
®
certi¿ed wireless
network deYice.
 Connect the optional wireless adapter US%-W/-5*) to the
USB TYPE A port
of the projector when using the wireless /AN. 
14 in the Operating *uide)
NOTE