18
2. Connection to the network
2.2
Connection via wired LAN
The connection Yia wired /AN is aYailable. Set wired /AN for the projector by
following the instructions of your network administrator when connecting to the
existing network.
1) Connect the projector to the computer Yia a hub
with a /AN cable CAT-5e or higher).
2) Press the MENU button on the remote control or
the control panel of the projector.
The MENU you last used will appear.
Use the cursor button to select the following.
EASY MENU > AD9ANCED MENU > NETWORK
> NETWORK SETUP > WIRED SETUP
3) Set the following items in WIRED SETUP.
䡡㻌㻌DHCP
䡡㻌IP ADDRESS
䡡㻌SU%NET MASK
䡡㻌DEFAU/T *ATEWAY
䡡㻌DNS SER9ER
As for setting an IP address, refer to About IP address.
19)
Select APP/Y, then press the ENTER button to reÀect the settings.
ʄ
Connection setup of wired LAN
hub
To Next Page
Loading...
