21
2.4 NETWORK Menu
2. Connection to the network
Remember that incorrect network settings on this
projector may cause trouble on the network. %e sure
to consult with your network administrator before
connecting to an existing access point on your
network.
Select “NETWORK” from the main menu to access
to the following functions.
The projector does not allow both wireless and wired /AN to be
connected to the same network.
If you do not use SNTP, then you must set the DATE AND TIME during the
initial installation.
OPTION menu in the Operating *uide)
The network function is not aYailable when STAND%Y MODE is set to
NETWORKWO/) or SA9IN* and the projector is in standby mode. Connect
the projector to the network after setting STAND%Y MODE to NORMA/.
SETUP menu in the Operating *uide)
When using wireless network function, set NETWORK - WIRE/ESS
NETWORK to ON.
NOTE
To Next Page
Loading...
