98
8.4 Command Control via the Network (continued)
6) Click the [Apply] button to saYe the settings.
When the authentication setting is enabled, the following settings are reTuired.
58)
7) Click the [Security Settings] on the main menu.
8) Click the [Network Control] and enter the desired password.
* See NOTE.
9) Click the [Apply] button to saYe the settings.
NOTE
8. Other Functions
The Password will be the same for Network Control Port1 (Port: 23),
Network Control Port2 (Port: 9715), PJLink Port (Port: 4352), My Image Port
(Port: 9716) and Messenger Port (Port: 9719).
The new con¿guration settings are actiYated after restarting the network
connection. When the con¿guration settings are changed, you must restart
the network connection. You can restart the network connection from Network
Restart on the main menu.
66)
To Next Page
Loading...
