Hitachi P-AP56NAM - Page 15

7.3 ELECTRICAL WIRING OF AIR PANEL P-AP56NAM
ON
12
ON
12
CN17
Air panel
PCB
Cable for auto swing motor
Connector
(CN17)
Earth screw
Electrical box
Indoor unit
Wire clamp
Control cable
Remote control switch cable
Power source cable
! CAUTION
• Performsecurelytheelectrical wiring work.Iftheelectricalworkis
notcompleted,heatgenerationattheconnection,areoranelectric
shockmayoccur.
• Makesurethatthewiresaresecurelyxedinordernottoapplyan
externalforcetotheterminalconnectionsofthewirings.Ifxingisnot
completed,heatgenerationorarewilloccur.
1 The following connectors are used in the air panel. Remove
the tape xing the wiring connectors on the air panel and pull
out them as shown in the gure below. Connect them with
the wiring connectors to CN17 in the electrical box as the
following gure.
? NOTE
Before the electrical wiring work, turn OFF the power source. If the
connectors are connected without turning OFF the power source, the
autoswinglouvercannotactivate.
2 After completing the wiring connection of the air panel,
attach the air inlet grille. Perform the attaching work in the
reverse procedure of removing. Hook the swivel of the
supporting string at
Ⓐ to the hole at the air panel. The air
inlet grille can be attached from any 4 directions by rotating
it. When multiple indoor units are installed or requested from
a user, the air intake grille direction can be selected freely.
Supporting string
Hole at air panel
Ⓐ Part
AIR PANEL P-AP56NAM
PMML0570 rev.0 - 01/2021
7
EN