Hitachi P-AP56NAM - Air Panel P-AP56 NAM; Installation Procedure

7 AIR PANEL P-AP56NAM
7.1 NAME OF PARTS
Air inlet grille
Louver
Air outlet
Air panel
P-AP56NAM
7.2 INSTALLATION
! CAUTION
Pay attention to perform the installation work at high-place using a
stepladder,etc.
? NOTE
• Donotmovethelouverbyhand.
• Ifmoved,thelouvermechanismwillbedamaged.
• Inaddition,donotapplyanexcessiveforcetotheairoutletpartto
preventthebreakage.
1 The suspension height of the indoor unit should be referred
to “Installation & Maintenance Manual” of the indoor unit.
2 Do not touch the louver during the installation work.
3 Remove the air inlet grille from the air panel.
While pushing both ends of knobs at the air inlet grille
toward the arrow direction, open the air inlet grille until the
angle of approximately 45° from the air panel surface. After
lifting the air inlet grille keeping it inclined, draw the air inlet
grille forward.
(Remove the lament tape (4 portions) xing the air lter.)
45°
Air inlet grille
Air panel
Corner pocket
cover (4 portions)
Knob
? NOTE
Althoughtheairinletgrillecanbeopeneduntiltheangleof90°fromthe
airpanelsurface,itcannotberemovedfromtheairpanel.
AIR PANEL P-AP56NAM
PMML0570 rev.0 - 01/2021
4