Hitachi PH - Setting Character Height and Character Orientation

3-33 ● Printing Characters
Character height
● The character height can be specified.
● The character height setting range is from 0 to 99.
Character width
● The character width can be specified.
● The character width setting range is from 0 to 199.
● When the product speed matching feature is incorporated (when the rotary
encoder is connected), set the character width as indicated below.
1
2
Ink drop use percentage setting Character width setting
1/1 002
1/2 001
1/3 to 1/16 000
3.4 Setting Character Height and Character Orientation
(1) Overview
● The procedure for setting the character height, character width, character orientation and
print start delay is described below.
The "Print specifications" first screen.
Character orientation
● Printing direction of characters can be set.
● Settings and print results are as shown below.
3
Setting Direction of transport Printing results
0 : A B C a← A B C 1 2 3
→
→b
1 : A B C a←
←
→b A B C 1 2 3
2 : a←
←
→b
3 : a←
→
→b
A B C 1 2 3
A B C 1 2 3
A B C 1 2 3
A B C
A B C
A B C 1 2 3
A B C 1 2 3
A B C 1 2 3
Direction of transport
b
For rotary encoder
wiring and setup, see
Section
1.5.3-6, Rotary encoder
signal.
Shut
down
Manual
Back
Show
corsor
←
→
Prev.
dis-
paly
Next
dis-
paly
Decre-
ment
Incre-
ment
123 456789
Print specifications Status: Ready
0
[ 0 ] (0-99)
Character width [ 0 0 2 ] (0-199)
Character orientation [ 0 ] (0: 1: ABC 2: 3: )
(Arrow: Printing direction) → ← ← →
Printing method 2 (1:single scan 2: )
9
Character height
Interlaced
ABC
a
A
B
C
1
2
3
ABCABC