Hitachi PH - Print Condition Transmission

● Standard Communication Functions 6-7
Assume that the printer is ready for printing.
1
6.3.3 Print Condition Transmission
● The procedure for changing the character height from "99" to "90" and change
the character width from "050" to "000."is shown in the example below.
From the "Print description" screen, press Print spec .
2
You can see a character height setting of 99 and character
width of "050" entered.
3
Transmit character height data and character width data from
the external device to the IJ printer.
5
Shows text data between STX and ETX
Transmission data
ESC Header 9 0 ESC Header 0 0 0
Transmission code
1BH 30H 39H 30H 1BH 31H 30H 30H 30H
Character width
Character height
Number of character
height digits
In the case of "2 digits"
Shut
down
Manual
Back
←
→
Prev.
dis-
paly
Next
dis-
paly
Decre-
ment
Incre-
ment
123 456789
Print specifications Status: Ready
0
[ 9 ] (0-99)
Character width [ 0 5 0 ] (0-199)
Character orientation [ 0 ] (0: 1: ABC 2: 3: )
(Arrow: Printing direction) → ← ← →
Printing method 2 (1:single scan 2: )
9
Character height
Interlaced
ABC
The character height setting then changes to "90".
The character width setting then changes to "000."
6
Shut
down
Manual
Back
←
→
Prev.
dis-
paly
Next
dis-
paly
Decre-
ment
Incre-
ment
123 456789
Print specifications Status: Ready
0
Character height [ 9 0 ] (0-99)
Character width [ 0 0 0 ] (0-199)
Character orientation [ 0 ] (0: 1: ABC 2: 3: )
(Arrow: Printing direction) → ← ← →
Printing method 2 (1:single scan 2: )
Interlaced
ABC
Show
cursor
Press the Manual key then press Online/Offline key.
The status then changes from "off-line (Com=0)" to "on-line (Com=1)".
4
Com=1
ABCABC
ABCABC