Open the maintenance cover and then pull out the reservoir.
Hold the reservoir and pull it forward.
1
Uncap the makeup ink reservoir and then add makeup ink.
2
7.4 Makeup ink Replenishment
(1) Overview
● While the printer is operated, the makeup ink is automatically transferred at fixed
intervals from the makeup ink reservoir to the main ink tank for replenishment
purposes.
● If the makeup ink low warning is issued, add makeup ink to the makeup ink
reservoir within 60 minutes. If such a replenishment procedure is not completed
within 60 minutes, the printer comes to a stop.
● The makeup ink can be added to the makeup ink reservoir without regard to the IJ
printer power ON/OFF status or operating status.
● Upon makeup ink replenishment, the alarm is automatically cleared.
(2) Operating procedure
● When moving the reservoir, move it gently.
Makeup ink reservoir
Maintenance cover
Pull out.
If makeup ink is accidentally
spilt, wipe it up promptly with
wiping paper or something
similar.
In addition, do not close the
maintenance cover until you
are sure that the wiped
portion has completely dried.
CAUTION
Fasten the cap of the makeup ink reservoir.
● Fasten it securely. Solvent components may evaporate.
3
Push the reservoir into its original position.
4
Close the maintenance cover.
5
● Gradually add the makeup ink to avoid spilling. Also, exercise care to avoid
excessive replenishment.
● If the mesh filter inside the cap is soiled, take it out and clean it.
To Next Page
Loading...
