5-10 ● Creating a User Pattern
Locate ↓ within the matrix which is displayed beside the pattern
creation area. Press this ↓ key four times consecutively.
The cursor then moves toward the lower left-hand corner of the matrix.
5
● The following two different cursors are used.
Move mode
Displayed:
The cursor is moved to a dot setup position.
Reversal mode
Displayed:
The dots at positions where the cursor has passed are reversed.
● To change the cursor type, press Invert next .
Press Invert next .
The cursor then enters the reversal mode.
6
● The following indications are given.
Dot present:
Dot not present:
● When you press Clear , the pattern generated in the creation area is erased.
Press two times consecutively.
The cursor then moves toward the upper right-hand corner.
7
↑
Press .
This causes the cursor to move toward the upper left-hand corner and reverse.
8
↑
To Next Page
Loading...
