Hitachi PH - Page 211

6-50 ● Warning Messages
Error
code
Name Description Check
014 Parity error The parity error occurred.
Check the baud rate and
data format.
015
Print format code
error
The print format data value was illegal.
Check the print format
transmission text
section.
016 Overrun error The overrun error occurred.
Check the baud rate and
data format.
017 Framing error The framing error occurred.
Check the baud rate and
data format.
019 2-byte code error
● An illegal 2-byte code (2 bytes per
character) was transmitted.
● Only one byte of 2-byte code was
transmitted.
Check the 2-byte code
transmission text.
020 Print data code error
● The print data registration number
was illegal.
● An unregistered number was
encountered.
Check the print data
recall / transmission
code.
021 SI/SO code error
The SI (shift in) or SO (shift out) code
position was illegal.
Check the printings
communication text.
022
User pattern
character size/
character code error
The character size or character code
values were illegal.
Check the user pattern
communication text.
023
High-speed
printing setup error
● When necessary conditions for high
speed printing were not satisfied, NM
or QM mode was transmitted.
● When High speed printing NM or
QM mode was set, a setting which
did not satisfy necessary conditions
for high speed printing was
transmitted.
Check the print
specifications
communication text.
024
Calendar/count
conditions error
● Transmitted to print item where
calendar/count characters were not
present.
● Set value was outside specifications.
● Zero suppression transmission was
performed to print item for which
barcode had been set.
Check calendar/count
condition
communication text.
026 Bar code setup error
● A character undefined for bar code
use was found in the printings.
● The number for ITF did not consist of
an even number of numerals
beginning with an odd digit position.
● The input data for EAN-13 was not
10 digits.
Check the printings print
format communication
text.
027 Printings error
● A dedicated character or katakana
was transmitted in a character size
which cannot be inputted.
● The three characters of a dedicated
character string were not properly
grouped.
● A count value is out of a count range.
● Count character was transmitted to
calendar item.
Check the printings
communication text