●Startup 2-3
No-cleaning stop : Stops ink ejection without cleaning.
Standby : Switches between the ready-for-printing state and standby state.
Manual Control Menu
Online/
Offline
No-cleaning
stop
Com=0
Manual
Shut
down
Menu
Standby
Cancel
● If the ink jets out continuously, a fault exists.
Press the Manual key to display the control menu. Press the No-cleaning stop
and OK keys in sequence to stop the ink ejection operation.
Press the Manual key.
Manual Control Menu
Press the No-cleaning stop key.
Press the OK key.
● For the subsequent operations, see Section 2.1.2, If a fault occurs at the
beginning of an operation.
● When the ink jets out, it may momentarily scatter and stain paper.
However, this does not indicate any abnormality at all.
Wait until the status changes from "Starting" to "Ready."
● If any startup fault occurs, see Section 2.1.2, If a fault occurs at the beginning
of an operation.
● When the temperature is low (below 20
℃ or so), it takes slightly longer for the
printer to become "Ready for printing" than at a normal temperature.
3
Input the print target detection signal and verify that the
printing state and printing contents are correct.
4
● When the print target detection
signal is entered while the
printer is "Ready," the
preselected print is made.
Shutdown Process Confirmation
Shutdown will stop the ink jet.
Solution To stop the ink jet, press [OK].
OK
Cancel
To Next Page
Loading...
