Hitachi PH - Page 63

2-8 ● Startup
(2) Switching between "Ready" state and "Standby" state
● When the conveyer interlock is put in operation by the Ready output signal, be careful not
to switch to "Standby" state since it will stop the conveyer.
Press the Manual key.
Switching from "Ready"
state to "Standby" state
Switching from "Standby"
state to "Ready" state
Manual Control Menu
Manual Control Menu
The control menu appears.
Press the Standby key.
Press the Ready key.
The confirmation screen opens.
Press the OK key.
Press the OK key.
1
2
3
● You can abort the operation by pressing the Cancel key from either the "Manual Control
Menu" screen or the confirmation screen.
Entering a deflection
voltage ON/OFF
signal executes the
same action.
(See Section 1.5.3-9,
Input for remote
control signals.)
See Section 1.5.3-1,
"Ready output signal".
No-cleaning stop : Stops ink ejection without cleaning.
Standby : Switches between the ready-for-printing state and standby state.
Manual Control Menu
Online/
Offline
No-cleaning
stop
Standby Cancel
No-cleaning stop : Stops ink ejection without cleaning.
Ready : Switches between the ready-for-printing state and standby state.
Manual Control Menu
Online/
Offline
No-cleaning
stop
Ready
Cancel
Printing will be aborted.
Print Abort Confirmation
OK
Cancel
Solution Press [OK] to abort.
The newly created print data will be printed.
Print Confirmation
OK
Cancel
Solution Press [OK] to print..
Shut
down
《
》
Menu
Com=0
Manual