HITEC Flash 8 User Manual

56 57
PROG.MIX cont.
23. Scroll to highlight the “TRIM” eld and press the jog dial to
activate the menu. With this feature enabled, the slave
feature will respond to trim changes as well as control inputs
for the master feature. When disabled, the slave feature
ignores trim changes and reacts only with control inputs to
the master feature.
24. Rotate the jog dial to select “OFF or “ON” and press the jog
dial to conrm your input.
See the “D/R & EXP” menu on page 49 for more information about exponential rates.
TipTip
Tip
You may also select a  ight condition in this menu by activating the desired  ight condition.
TipTip
Tip
18. Select neutral sensitivity with jog dial and press the
jog dial to conrm setting.
19. Scroll to highlight “OST” and press the jog dial to activate
the menu.
20. Use the jog dial to set the Oset value (increase or decrease)
of the servo, then press the jog dial to conrm setting.
21. scroll to highlight “SPEED” and press the jog dial to
activate the menu.
22. Use the jog dial to set the speed of slaver servo,
then press the jog dial to conrm setting.
PROG.MIX cont.
26. Press the jog dial again to enable selections in the S/W menu.
27. Scroll to select the switch that you will use to activate the
mix and press the jog dial to conrm your selection. If “NULL”
is selected, the mix will always be active.
28. If you selected a switch, the switch position menu will
appear. Scroll to highlight the switch position(s) that you
will use to enable the mix. Press the jog dial to conrm your
selection.
30. Set up accordance with Flight Condition
- The upper right  eld of the menu displays which  ight
condition is currently active and will be programmed.
- Scroll to the Flight Condition  eld and press the jog dial to
activate the menu.
- Choose the desired  ight condition and press the jog dial to
con rm your selection
- Repeat steps 9-24 to de ne the settings for each  ight condition.
31. Press the back button to return to the model function menu.
31. To inhibit this mix, scroll to the “MIX” eld and press the jog
dial to activate the menu.
32. Scroll to select “INH” and press the jog dial to conrm your
selection.
33. Press the back button twice to return to the model function
menu.
29. Scroll to select “ON” and press the jog dial to conrm your
selection. If you toggle the selected switch, the eld in the
top right corner of the screen will indicate if the mix is on or
o.
30. Press the back button to return to the programmable mix
sub-menu.
25. Scroll to highlight “S/W” and press the jog dial to activate the
menu.

HITEC Flash 8 Specifications

General

Interface	-
Input type	Press buttons
Product color	Black, Silver
Built-in display	Yes
Maximum range	- m
Frequency band	2.4 GHz
Channels quantity	8 channels

Weight and Dimensions

Weight	- g