What to do if there is a short circuit of the safety switch on HMF Control Systems?
If there is a short circuit of the safety switch in your HMF Control Systems (a high signal is expected, but there is a low signal), the system will automatically reset. Remove all plugs and restart the system.
What to do if there is wrong voltage for the safety switch of HMF Scanreco G2 Control Systems?
If the voltage for the safety switch in your HMF Control Systems is incorrect (a low signal is expected, but there is a high signal), the system will automatically reset. Remove all plugs and restart the system.
What to do if there is wrong voltage on a digital output of HMF Scanreco G2?
If there's an incorrect voltage on one of the digital output terminals 1-14 of your HMF Control Systems (a low signal is expected, but there is a high signal), the system will automatically reset. Inspect all digital output terminals, remove the plug, and restart the system.
What to do if there is a short circuit on a digital output of HMF Scanreco G2 Control Systems?
If you observe a short circuit on one of the digital output terminals 1-14 of your HMF Control Systems (a high signal is expected, but there is a low signal), the system will automatically reset. Check all digital output terminals, remove the plug, and restart the system.
What to do if the voltage on the DV output of HMF Scanreco G2 is incorrect?
If the voltage on the DV output of your HMF Control Systems is incorrect (a low signal is expected, but it's high, possibly due to externally induced voltage), examine the DV output, cable, and plug. Disconnect the plug and then restart the system.
Details the components of the Scanreco G2 radio remote control system.
Describes CAN control of PVED electric activations for crane functions.
Details proportional voltage control for PVE electric activations.
Explains proportional current control for PWM electric activations.
Describes digital voltage control for ON-OFF solenoid valves.
Discusses the combination of different radio remote control functions.
Covers the 14 digital outputs for various functions like engine control.
Guides on proper installation of the radio controller for optimal performance.
Checks and verifies the status of ID coding.
Lists common causes for failure during the ID coding process.
General| Brand | HMF |
|---|---|
| Model | Scanreco G2 |
| Category | Control Systems |
| Language | English |
To Next Page