‘‘ ’’
71
Do not turn the engine switch
key to the START position while
the engine is running.
The starter motor consumes a
large amount of current. Do not
therefore run it continuously for
more than 5 seconds at a time. If
the engine does not start within 5
seconds, wait at least 10 seconds
before running the starter motor
again.
STARTING THE ENGINE
ENGINE SWITCH KEY
START
ON
OFF
COOLING WATER
CHECK HOLE
COOLING WATER INTAKE PORT
(each side)
After starting, check whether the
cooling water is flowing out of the
cooling wat er check hole. Amount
of water flowing out of the check
hole might vary due to the
thermostat operation, but this is
normal.
Turn the engine switch key to the
START position and hold it there
until the engine starts.
The Neutral Starting System
preve nts the engine from being
started unless the control lever is set
in the N (neutral) position even
though the engine is cranked by the
starting motor.When the engine starts, release the
key, allowing it to return to the ON
position.
4. 5.
To Next Page
Loading...
