Honeywell 200 Series User Manual

•
SECTION V. TYPE 214-2 CARD READER/PUNCH
REFERENCE EDGE INDICATOR (PUNCH)
Start Procedures
1. To perform an initial start following a central processor power up:
a. Press the POWER ON switch.
b. Press the RUNOUT switch. This action resets error-check
conditions and clear s the card path.
c.
Load the input deck into the input hopper face down, nines
edge first.
d. Press the START switch. If it is desired to stop the reader/
punch while read or punch operations are in progress, the
STOP switch may be pressed.
Restart Procedures
1. To restart following a STOP switch depression (a normal stop with no
error conditions indicated):
a. Press the START switch.
2. To restart following a stop condition for a CARDS indication:
a. Refill the empty input hopper or empty the full output stacker
as required, and/ or insure the cards are pressed against the
stacker-pressure switch.
NOTE: When the reader/punch is running, care should be
taken in removing cards from the output stacker
to avoid a possible CARDS indication and a sub-
sequent halt.
b. Press the START switch.
3. To restart following a stop condition for an INPUT indication:
a. Remove the cards from the input hopper.
b.
Check the device for a card jam condition. The cards causing
the feed failure are nearest the throat (as the deck is removed).
These cards mayor may not be damaged or bent out of shape.
5-6
--"-
i
I

Honeywell 200 Series Specifications

General

Brand	Honeywell
Model	200 Series
Category	Desktop
Language	English