Honeywell Gamewell-FCI GWF-7075 - 1: Input Point Mapping; 2: Output Circuit Mapping; 3: Event Mapping

40 GWF-7075 Addressable Fire Alarm Control Panel Manual — P/N LS10147-002GF-E:E 06/11/2019
Programming Overview Mapping Overview
6.2.3 Event Mapping
You can map the following types of Events. For each Event Type, you can activate the Output Groups with specific Output Patterns. refer
to Figure 6.4, 6.5 and 6.6 for Mapping Events.
Table 6.3 lists the types of Events that correspond to the System category.
Figure 6.4 Example of Zone Events Mapped to Output Groups and Patterns
6.2.1 Input Point Mapping 6.2.2 Output Circuit Mapping
Input Points are assigned to input zones. Any input point can be
assigned to any input zone. (Input points can be assigned to one
zone only. You can designate an Input Point as “Unused,” which
means it has not been assigned to a zone).
Figure 6.3 is a simple example showing how to assign notification
and relay output circuits to groups. For an example of a simple floor
above/floor below application, see Figure 6.3.
Figure 6.2 Input Point Assignment Example
Figure 6.3 Assigning Output Circuits to Groups Example
Pt. 1
Pt. 2
Pt. 3
Pt. 4
Pt. 5
Pt. 6
Pt. 7
Pt. 8
Pt. 9
Pt. 70
Pt. 71
Pt. 72
Pt. 73
Pt. 74
Pt. 75
Zone 1
Zone 2
Zone 3
Zone 4
Zone 5
Zone 6
Zone 124
Zone 125
Zone 123
Output Circuit 1
Notification Circuit
Output Circuit 2
Aux. Power Output
Output Circuit 3
Relay 1
Output Circuit 4
Relay 2
Aux. power
outputs are
not mapped to
output groups
In this example,
all notification
outputs are
assigned to
Group 1
JumpStart
creates
Group 124 &
Group 124 for
Relay 1 & 2
Group 1
Group 2
Group 124
Group 125
• 11 types of Zone Events • 14 types of Panel Events • 6 types of Site Events
System Zone Panel Site
Fire
Manual Pull Alarm Interlock Release System Aux 1 Alarm Fire Drill
Water Flow Alarm Pre-Alarm System Aux 2 Alarm General Fire Alarm
Detector Alarm
(heat or smoke detectors)
Fire Supervisory General Fire Supervisory
Zone Aux 1 Alarm Status Point General Fire Pre-Alarm
Zone Aux 2 Alarm CO Alarm
Interlock Alert CO Supervisory
Advisory
Zone Panel Site
Trouble SBUS Expander Trouble Battery Trouble General Trouble F1 Key Active
Status Point Active SBUS Class A Trouble Ground Fault Trouble Site Silenced F2 Key Active
SLC Loop Trouble Phone Line Trouble F3 Key Active
AC Loss Trouble Reporting Account Trouble F4 Key Active
Table 6.3 Event Types
Zone 1:
Manual Pull Alarm
Pattern 00
Constant
Pattern 02
ANSI 3.41
Group 1
Group 2
Group 3
Group 4
Group 5
Group 6
Group 7