84 GWF-7075 Addressable Fire Alarm Control Panel Manual — P/N LS10147-002GF-E:E 06/11/2019
Using the Built-In Programmer to Edit Text Characters Used to Edit Text
Appendix A: Using the Built-In Programmer to Edit Text
This section contains tables of programmable characters that you can use for the following labels:
Use T9 style editing.
A.1 Characters Used to Edit Text
Table 1.A lists the available characters and their associated numeric designator. When you program, do the fol-
lowing:
1. Use the <Up> or <Down> arrow key to scroll to the mode you want.
2. Press the number shown in Table 1.A until the character you selected appears.
3. Press the <Left> or <Right> arrow for position, and press <Enter> to accept.
A.2 Example Name Edit
1. Press the <Up> or <Down> arrow key to select the upper case letters mode, Press 2 until “F” appears.
2. Press the <Up> or <Down> arrow key to change the mode to the lower case letters, Press 3 until “i”
appears.
3. Press 6 until “r” appears.
4. Press 2 until “e” appears.
5. Press 0 to space, then continue to the next word using the same process.
6. Press <Enter> to accept.
Figure A.1: Edit Name Example
• device • site • group
• module • template • zone names
Lower Case Letters
abc1 def2 ghi3 jkl4
mno5 pqr6 stu7 vwx8
yz9 Spc0
Upper Case Letters
ABC1 DEF2 GHI3 JKL4
MNO5 PQR6 STU7 VWX8
YZ9 Spc0
Numbers and Special Characters
1
[ ]1 2 ()2 3 . ,3 4 :;4
5 ’ "5 6 ? !6 7 ‘ /7 8 – +8
9 = -9 00 * & @ * # $ #
Table A.1 : Character Table
NOTE: After three seconds of no change, the letter will automatically be accepted. Also, if you
press the next number, it will automatically accept the previous selection.
To Next Page
Loading...
